5 facility lock/unlock - +clck – Rainbow Electronics GM862-QUAD-PY User Manual

Page 87

AT Commands Reference Guide

80000ST10025a Rev. 5 - 09/07/08

page 87 of 434

+COPS - Operator Selection

SELINT 0 / 1

1 - available
2 - current
3 - forbidden

Note: since with this command a network scan is done, this command may
require some seconds before the output is given.

Reference GSM

07.07

3.5.4.3.5 Facility Lock/Unlock - +CLCK

+CLCK - Facility Lock/Unlock

SELINT 0 / 1

AT+CLCK=
,
[,
[,]]

Execution command is used to lock or unlock a ME o a network facility.

Parameters:
- facility
"SC" - SIM (PIN request) (device asks SIM password at power-up and

when this lock command issued)

"AO"- BAOC (Barr All Outgoing Calls)
"OI" - BOIC (Barr Outgoing International Calls)
"OX" - BOIC-exHC (Barr Outgoing International Calls except to Home

Country)

"AI" - BAIC (Barr All Incoming Calls)
"IR" - BIC-Roam (Barr Incoming Calls when Roaming outside the home

country)

"AB" - All Barring services (applicable only for =0)
"AG" - All outGoing barring services (applicable only for =0)
"AC" - All inComing barring services (applicable only for =0)
"FD" - SIM fixed dialling memory feature (if PIN2 authentication has not

been done during the current session, PIN2 is required as
)

"PN" - network Personalisation
"PU" - network subset Personalisation

- defines the operation to be done on the facility
0 - unlock facility
1 - lock facility
2 - query status

- shall be the same as password specified for the facility from

the DTE user interface or with command Change Password
+CPWD

- sum of integers each representing a class of information (default

is 7)

1- voice (telephony)
2 - data (refers to all bearer services)
4 - fax (facsimile services)