Rainbow Electronics GM862-QUAD-PY - Manual (Page 366)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 366 of 434
#EUSER - E-mail Authentication User Name SELINT 0 / 1
#EUSER:
AT#EUSER=? Test command returns the maximum allowed length of the string parameter
.
Example AT#EUSER="myE-Name"
OK
AT#EUSER?
#EUSER: "myE-Name"
OK
Note It is a different user field than the one used for GPRS authentication (see
#USERID).
#EUSER - E-mail Authentication User Name
SELINT 2
AT#EUSER=
[] Set command sets the user identification string to be used during the
authentication step of the SMTP.
Parameter:
- e-mail authentication User ID, string type.
- any string value up to max length reported in the Test command.
(factory default is the empty string “”)
Note: if no authentication is required then the parameter shall be
empty "".
AT#EUSER? Read command reports the current user identification string, in the format:
#EUSER:
AT#EUSER=? Test command returns the maximum allowed length of the string parameter
.
Example AT#EUSER="myE-Name"
OK
AT#EUSER?
#EUSER: "myE-Name"
OK
Note It is a different user field than the one used for GPRS authentication (see
#USERID).
3.5.7.6.4 E-mail Authentication Password - #EPASSW
#EPASSW - E-mail Authentication Password SELINT 0 / 1
AT#EPASSW=
Set command sets the password string to be used during the authentication
step of the SMTP.
Parameter:
- e-mail authentication password, string type.
- any string value up to max length reported in the Test command.