Rainbow Electronics GM862-QUAD-PY - Manual (Page 38)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 38 of 434
&V - Display Current Base Configuration And Profile SELINT 0 / 1 / 2
Note: the row of information about CTS (C106) OPTIONS is in the output of
&V only for compatibility reasons and represents only a dummy value.
3.5.3.1.15 Display Current Configuration And Profile - &V0
&V0 - Display Current Configuration And Profile SELINT 0 / 1 / 2
AT&V0 Execution command returns all the configuration parameters settings.
Note: this command is the same as &V, it is included only for backwards
compatibility.
Note: this is one of the commands whose output differs depending on the
last #SELINT setting.
Note: the row of information about CTS (C106) OPTIONS is in the output of
&V0 only for compatibility reasons and represents only a dummy value.
3.5.3.1.16 S Registers Display - &V1
&V1 - S Registers Display SELINT 0 / 1 / 2
AT&V1 Execution command returns the value of the S registers in decimal and
hexadecimal value in the format:
REG DEC
HEX
...
where
n> - S register number
000..005
007
012
025
038
- current value in decimal notation
- current value in hexadecimal notation
3.5.3.1.17 Extended S Registers Display - &V3
&V3 - Extended S Registers Display SELINT 0 / 1 / 2
AT&V3 Execution command returns the value of the S registers in decimal and
hexadecimal value in the format:
REG DEC
HEX