Rainbow Electronics GM862-QUAD-PY - Manual (Page 272)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 272 of 434
#AUTOATT - Auto-Attach Property SELINT 2
command #AUTOATT=1 has been issued (and at every following
startup) the terminal will automatically try to attach to the GPRS service.
AT#AUTOATT? Read command reports whether the auto-attach property is currently
enabled or not, in the format:
#AUTOATT:
AT#AUTOATT=? Test command reports available values for parameter .
3.5.7.1.42 Multislot Class Control - #MSCLASS
#MSCLASS - Multislot Class Control SELINT 0 / 1
AT#MSCLASS[=
,
] Set command sets the multislot class
Parameters:
- multislot class; take care: class 7 is not supported.
1..6 - GPRS class
8..10 - GPRS class
0 - the new multislot class is enabled only at the next detach/attach or
after a reboot.
1 - the new multislot class is enabled immediately, automatically forcing a
detach / attach procedure.
Note: the range for former GM862 family products is 1..8,
excluding class 7.
Note: if all parameters are omitted the behaviour of set command is the
same as read command.
AT#MSCLASS? Read command reports the current value of the multislot class in the
format:
#MSCLASS:
AT#MSCLASS=? Test command reports the range of available values for parameter .
#MSCLASS - Multislot Class Control
SELINT 2
AT#MSCLASS=
[,
] Set command sets the multislot class
Parameters:
- multislot class; take care: class 7 is not supported.
1..6 - GPRS class
8..10 - GPRS class
0 - the new multislot class is enabled only at the next detach/attach or
after a reboot.
1 - the new multislot class is enabled immediately, automatically forcing a
detach / attach procedure.