Rainbow Electronics GM862-QUAD-PY - Manual (Page 120)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 120 of 434
+CPIN - Enter PIN SELINT 2
#SHDN #CSURVUC +CREG $GPSWK
#WAKE #CSURVB +COPS $GPSSAV
#QTEMP #CSURVBC +CLIP $GPSRST
#GPIO #CSURVF +CPAS $GPSCON
#ADC +CFUN $GPSPRG
All the above commands, but the ones in the grayed cells, can be issued
even if the SIM card is not inserted yet.
All the above commands, but +CSDH and +CNMI, can be issued even if ME
is waiting for phone-To-SIM card password to be given
Reference GSM 07.07
3.5.4.4.4 Signal Quality - +CSQ
+CSQ - Signal Quality SELINT 0 / 1
AT+CSQ Execution command reports received signal quality indicators in the form:
+CSQ: ,
where
- received signal strength indication
0 - (-113) dBm or less
1 - (-111) dBm
2..30 - (-109)dBm..(-53)dBm / 2 dBm per step
31 - (-51)dBm or greater
99 - not known or not detectable
- bit error rate (in percent)
0 - less than 0.2%
1 - 0.2% to 0.4%
2 - 0.4% to 0.8%
3 - 0.8% to 1.6%
4 - 1.6% to 3.2%
5 - 3.2% to 6.4%
6 - 6.4% to 12.8%
7 - more than 12.8%
99 - not known or not detectable
Note: this command should be used instead of the %Q and %L commands,
since GSM relevant parameters are the radio link ones and no line is
present, hence %Q %L and have no meaning.
AT+CSQ? Read command has the same effect as Execution command.
AT+CSQ=? Test command returns the supported range of values of the parameters
and .