Rainbow Electronics GM862-QUAD-PY - Manual (Page 247)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 247 of 434
#STM - Signaling Tones Mode SELINT 0 / 1
enabled or not, in the format:
#STM:
AT#STM=? Test command reports supported range of values for parameter .
#STM - Signaling Tones Mode
SELINT 2
AT#STM=
[] Set command enables/disables the signaling tones output on the audio path
selected with #SRP command
Parameter:
- signaling tones status
0 - signaling tones disabled
1 - signaling tones enabled
2 - all tones disabled
Note:
AT#STM=0 has the same effect as AT+CALM=2;
AT#STM=1 has the same effect as AT+CALM=0.
AT#STM? Read command reports whether the current signaling tones status is
enabled or not, in the format:
#STM:
AT#STM=? Test command reports supported range of values for parameter .
3.5.7.1.14 Tone Playback - #TONE
#TONE - Tone Playback SELINT 2
AT#TONE=
[,] Execution command allows the reproduction of DTMF tones, standard free
tone, standard busy tone and a set of user defined tones for a certain time.
Parameters:
- ASCII characters, range is ((0-9),#,*,(A-D),(G-L),Y,Z);
- (0-9), #,*,(A-D): DTMF tone
- (G-L): User Defined Tones
- Y: free tone
- Z: busy tone
- Duration of current tone in 1/10 of Sec.
1..300 - tenth of seconds (default is 30)
AT#TONE=? Test command returns the supported range of values for parameters
and .
3.5.7.1.15 Tone Classes Volume
#TSVOL – Tone Classes Volume SELINT 2
AT#TSVOL= Set command is used to select the volume mode for one or more tone