Rainbow Electronics GM862-QUAD-PY - Manual (Page 312)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 312 of 434
3.5.7.1.85 TeleType Writer - #TTY
#TTY - TeleType Writer SELINT 2
AT#TTY= Set command enables/disables the TTY functionality.
Parameter:
0 - disable TTY functionality
1 - enable TTY functionality
AT#TTY? Read command returns whether the TTY functionalityis currently enabled or
not, in the format:
#TTY:
AT#TTY=? Test command reports the supported range of values for parameter
.
3.5.7.1.86 CPU Clock Mode - #CPUMODE
#CPUMODE - CPU Clock Mode SELINT 2
AT#CPUMODE=
Set command specifies the CPU clock mode
Parameter:
0 - normal CPU clock
1 - fast CPU clock
2 - fast CPU clock, during GPRS TX/RX only
Note: using =1, the power consumption will increase
AT#CPUMODE? Read command returns the currently selected CPU clock mode in the
format:
#CPUMODE:
AT#CPUMODE=? Test command reports the supported range of values for parameter
.
3.5.7.1.87 GSM Context Definition -#GSMCONT
#GSMCONT - GSM Context Definition SELINT 2
AT#GSMCONT=
[,,
] Set command specifies context parameter values for the only GSM context,
identified by the (local) context identification parameter 0.
Parameters:
- context Identifier; numeric parameter which specifies the only GSM