Rainbow Electronics GM862-QUAD-PY - Manual (Page 356)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 356 of 434
#SKTL - Socket Listen SELINT 2
to stop listening
AT#SKTL=0,0,1024, 255
OK
Note The main difference between this command and #SKTD is that #SKTL
does not contact any peer, nor does any interaction with the GPRS context
status, leaving it ON or OFF according to the #GPRS setting, therefore
when the connection made with #SKTL is closed the context (and hence
the local IP address) is maintained.
3.5.7.5.17 Socket Listen Improved - @SKTL
@SKTL - Socket Listen Improved SELINT 0 / 1
AT@SKTL
[=,
,
,
[]] Execution command opens/closes the socket listening for connection
requests.
Parameters:
- socket mode
0 - closes socket listening
1 - starts socket listening
- socket protocol type
0 - TCP
- local host input port to be listened
0..65535 - port number
- socket closure behaviour for TCP
0 - local host closes immediately when remote host has closed (default)
255 - local host closes after an escape sequence (+++) or after an abortive
disconnect from remote.
Command returns the OK result code if successful.
Note: the command to be successful requests that:
- the GPRS context 1 is correctly set with +CGDCONT
- the authentication parameters are set (#USERID, #PASSW)
- the GPRS coverage is enough to permit a connection
- the GPRS has been activated with AT#GPRS=1
When a connection request comes on the input port, if the sender is not
filtered by the internal firewall (see command #FRWL), an unsolicited code
is reported:
+CONN FROM:
Where:
- host address of the remote machine that contacted the
device.