Rainbow Electronics GM862-QUAD-PY - Manual (Page 375)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 375 of 434
3.5.7.6.10 SMTP Read Message - #EMAILMSG
#EMAILMSG - SMTP Read Message SELINT 0 / 1
AT#EMAILMSG Execution command returns the last response from SMTP server.
AT#EMAILMSG? Read command has the same behaviour as Execution command.
#EMAILMSG - SMTP Read Message
SELINT 2
AT#EMAILMSG Execution command returns the last response from SMTP server.
AT#EMAILMSG=? Test command returns the OK result code.
3.5.7.7 Easy Scan® Extension AT Commands
Note: it is strongly suggested to issue all the Easy Scan® Extension AT commands with NO
SIM inserted, to avoid a potential conflict with normal module operations, such as “incoming
call”, “periodic location update, “periodic routing area update” and so on.
3.5.7.7.1 Network Survey - #CSURV
#CSURV - Network Survey SELINT 0 / 1
AT#CSURV
[=,]
AT*CSURV
[=,]
(both syntax are
possible) Execution command allows to perform a quick survey through channels
belonging to the band selected by last #BND command issue, starting from
channel to channel . If parameters are omitted, a full band scan is
performed.
Parameters:
- starting channel
- ending channel
After issuing the command the device responds with the string:
Network survey started…
and, after a while, a list of informations, one for each received carrier, is
reported, each of them in the format:
(For BCCH-Carrier)
arfcn: bsic: rxLev: ber: mcc:
mnc: lac: cellId: cellStatus:
numArfcn: arfcn: [ ..[ ]]
[numChannels: array: [ ..[]] [pbcch:
[nom: rac: spgc: pat: nco:
t3168: t3192: drxmax: ctrlAck:
bsCVmax: alpha: pcMeasCh: ]]]