Rainbow Electronics GM862-QUAD-PY - Manual (Page 171)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 171 of 434
+CPMS - Preferred Message Storage SELINT 0 / 1
- memory to which received SMs are preferred to be stored
"SM" - SIM SMS memory storage
The command returns the memory storage status in the format:
+CPMS: ,,,,,
where
- number of SMs stored into
- max number of SMs that can contain
- number of SMs stored into
max number of SMs that can contain
- number of SMs stored into
- max number of SMS that can contain
Note: The only supported memory storage for writing and sending SMs is
the SIM internal memory "SM", so =="SM".
Note: the received class 0 SMS are stored in the "ME" memory regardless
the setting and they are automatically deleted at power off.
Note: If all parameters are omitted the behavior of Set command is the
same as Read command.
AT+CPMS? Read command reports the message storage status in the format:
+CPMS: ,,,,,,
,,
where , and are the selected storage memories
for reading, writing and storing respectively.
AT+CPMS=? Test command reports the supported values for parameters ,
and
Example AT+CPMS?
+CPMS: "SM",5,10,"SM",5,10,"SM",5,10
OK
you have 5 out of 10 SMS SIM positions occupied
Reference GSM 07.05
+CPMS - Preferred Message Storage
SELINT 2
Note: the behaviour of command +CPMS differs depending on whether or not the improved SMS
commands operation mode has been enabled (see #SMSMODE)
(#SMSMODE=0)
#
S
M
AT+CPMS=
[, Set command selects memory storages , and
to be used for reading, writing, sending and storing SMs.