Rainbow Electronics GM862-QUAD-PY - Manual (Page 239)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 239 of 434
#CGMM - Model Identification SELINT 2
AT#CGMM=? Test command returns the OK result code.
3.5.7.1.4 Revision Identification - #CGMR
#CGMR - Revision Identification SELINT 0 / 1
AT#CGMR Execution command returns device software revision number with
command echo.
AT#CGMR? Read command has the same effect as the Execution command
#CGMR - Revision Identification
SELINT 2
AT#CGMR Execution command returns device software revision number with command
echo.
AT#CGMR=? Test command returns the OK result code.
3.5.7.1.5 Product Serial Number Identification - #CGSN
#CGSN - Product Serial Number Identification SELINT 0 / 1
AT#CGSN Execution command returns the product serial number, identified as the
IMEI of the mobile, with command echo.
AT#CGSN? Read command has the same effect as the Execution command
#CGSN - Product Serial Number Identification
SELINT 2
AT#CGSN Execution command returns the product serial number, identified as the IMEI
of the mobile, with command echo.
AT#CGSN=? Test command returns the OK result code.
3.5.7.1.6 International Mobile Subscriber Identity (IMSI) - #CIMI
#CIMI - International Mobile Subscriber Identity (IMSI) SELINT 0 / 1
AT#CIMI Execution command returns the international mobile subscriber identity,
identified as the IMSI number, with command echo.
AT#CIMI? Read command has the same effect as the Execution command
#CIMI - International Mobile Subscriber Identity (IMSI)
SELINT 2
AT#CIMI Execution command returns the international mobile subscriber identity,
identified as the IMSI number, with command echo.
AT#CIMI=? Test command returns the OK result code.
3.5.7.1.7 Read ICCID (Integrated Circuit Card Identification) - #CCID
#CCID - Read ICCID SELINT 2
AT#CCID Execution command reads on SIM the ICCID (card identification number
that provides a unique identification number for the SIM)
AT#CCID=? Test command returns the OK result code.