Rainbow Electronics GM862-QUAD-PY - Manual (Page 305)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 305 of 434
#SKIPESC - Skip Escape Sequence SELINT 0 / 1
Parameter:
0 - doesn’t skip the escape sequence; its transmission is enabled (factory
default).
1 - skips the escape sequence; its transmission is not enabled.
Note: in case of an FTP connection, the escape sequence is not
transmitted, regardless of the command setting.
Note: issuing AT#SKIPESC is the same as issuing the Read
command.
Note: issuing AT#SKIPESC= is the same as issuing the command
AT#SKIPESC=0.
AT#SKIPESC? Read command reports whether escape sequence skipping is currently
enabled or not, in the format:
#SKIPESC:
AT#SKIPESC=? Test command reports supported range of values for parameter .
#SKIPESC - Skip Escape Sequence
SELINT 2
AT#SKIPESC=
[] Set command enables/disables skipping the escape sequence +++ while
transmitting during a data connection.
Parameter:
0 - doesn’t skip the escape sequence; its transmission is enabled (factory
default).
1 - skips the escape sequence; its transmission is not enabled.
Note: in case of an FTP connection, the escape sequence is not
transmitted, regardless of the command setting.
AT#SKIPESC? Read command reports whether escape sequence skipping is currently
enabled or not, in the format:
#SKIPESC:
AT#SKIPESC=? Test command reports supported range of values for parameter .
3.5.7.1.78 Escape Sequence Guard Time - #E2ESC
#E2ESC - Escape Sequence Guard Time SELINT 0 / 1