Rainbow Electronics GM862-QUAD-PY - Manual (Page 92)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 92 of 434
+CPWD - Change Facility Password SELINT 2
“PS”- SIM VO
- string type, it shall be the same as password specified for the
facility from the ME user interface or with command +CPWD.
- string type, it is the new password
Note: parameter is the old password while is the new
one.
AT+CPWD=? Test command returns a list of pairs (,) which presents
the available facilities and the maximum length of their password
()
Example at+cpwd=?
+CPWD: ("SC",8),("AB",4),("P2",8),("PS",8)
OK
Reference GSM 07.07
3.5.4.3.8 Calling Line Identification Presentation - +CLIP
+CLIP - Calling Line Identification Presentation SELINT 0 / 1
AT+CLIP[=[]] Set command enables/disables the presentation of the CLI (Calling Line
Identity) at the TE. This command refers to the GSM supplementary service
CLIP (Calling Line Identification Presentation) that enables a called
subscriber to get the CLI of the calling party when receiving a mobile
terminated call.
Parameters:
0 - disables CLI indication (factory default)
1 - enables CLI indication
If enabled the device reports after each RING the response:
+CLIP: ,,””,128,,
where:
- string type phone number of format specified by
- type of address octet in integer format
128 - both the type of number and the numbering plan are unknown
129 - unknown type of number and ISDN/Telephony numbering plan
145 - international type of number and ISDN/Telephony numbering plan
(contains the character "+")
- string type; alphanumeric representation of
corresponding to the entry found in phonebook; used character
set should be the one selected with command Select TE
character set +CSCS.