Rainbow Electronics GM862-QUAD-PY - Manual (Page 66)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 66 of 434
S25 -Delay To DTR Off SELINT 2
Parameter:
- expressed in hundredths of a second
0..255 - factory default value is 5.
Note: the delay is effective only if its value is greater than 5.
ATS25? Read command returns the current value of S25 parameter.
Note: the format of the numbers in output is always 3 digits, left-filled with 0s
3.5.3.7.4 Disconnect Inactivity Timer - S30
S30 - Disconnect Inactivity Timer SELINT 0 / 1
ATS30[=] Set command defines the inactivity time-out in minutes. The device
disconnects if no characters are exchanged for a time period of at least
minutes.
Parameter:
- expressed in minutes
0 - disabled, disconnection due to inactivity is disabled (factory default).
1..255 - inactivity time-out value.
ATS30? Read command returns the current value of S30 parameter.
ATS30=? Test command returns the range for without command echo and
parenthesis.
Note: the output depends on the choice made through #SELINT command.
Note For either Read and Test command the format of the numbers in output is
always 3 digits, left-filled with 0s
S30 -Disconnect Inactivity Timer
SELINT 2
ATS30=[] Set command defines the inactivity time-out in minutes. The device
disconnects if no characters are exchanged for a time period of at least
minutes.
Parameter:
- expressed in minutes
0 - disabled, disconnection due to inactivity is disabled (factory default).
1..127 - inactivity time-out value
ATS30? Read command returns the current value of S30 parameter.
Note: the format of the numbers in output is always 3 digits, left-filled with 0s
3.5.3.7.5 Delay Before Forced Hang Up - S38
S38 -Delay Before Forced Hang Up SELINT 0 / 1
ATS38[=] Set command sets the delay, in seconds, between the device’s receipt of H