Rainbow Electronics GM862-QUAD-PY - Manual (Page 302)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 302 of 434
previous setting was different from AT#AUTOBND=2
b PLMN list not fixed (AT#PLMNMODE=1).
Note: the new setting will be available just at first next power-up.
Note: If ‘Four Band’ Automatic Band Selection has been activated
(AT#AUTOBND=2), at power-up the value returned by AT#BND? could be
different from 3 when ENS functionality is enabled.
AT#ENS? Read command reports whether the ENS functionality is currently enabled
or not, in the format:
#ENS:
where:
as above
AT#ENS=? Test command reports the available range of values for parameter .
Reference Cingular Wireless LLC Requirement
3.5.7.1.75 Select Band - #BND
#BND - Select Band SELINT 0 / 1
AT#BND[=
[]] Set command selects the current band.
Parameter
:
0 - GSM 900MHz + DCS 1800MHz
1 - GSM 900MHz + PCS 1900MHz
2 - GMS 850MHz + DCS 1800MHz (available only on quadri-band
modules)
3 - GMS 850MHz + PCS 1900MHz (available only on quadri-band
modules)
Note: This setting is maintained even after power off.
Note: issuing AT#BND is the same as issuing the Read command.
Note: issuing AT#BND= is the same as issuing the command
AT#BND=0.
AT#BND? Read command returns the current selected band in the format:
#BND:
AT#BND=? Test command returns the supported range of values of parameter .
Note: the range of values differs between triband modules and quadric-band
modules
#BND - Select Band
SELINT 2