Rainbow Electronics GM862-QUAD-PY - Manual (Page 399)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 399 of 434
#STIA - SIM Tookit Interface Activation SELINT 2
SMS messages with command +CNMI.
AT#STIA=? Test command returns the range of available values for the parameters
and .
Note Just one instance at a time, the one which first issued AT#STIA=n (with n
different from zero), is allowed to issue SAT commands, and this is valid till
the same instance issues AT#STIA=0.
After power cycle another instance can enable SAT.
Note A typical SAT session on AT interface starts after an #STN: 37 unsolicited
code is received, if enabled(see above). At that point usually an
AT#STGI=37 command is issued (see #STGI), and after the SAT main
menu has been displayed on TE an AT#STSR=37,0,x command is issued
to select an item in the menu (see #STSR).
3.5.7.8.2 SIM Tookit Get Information - #STGI
#STGI - SIM Tookit Get Information SELINT 2
AT#STGI=
[] #STGI set command is used to request the parameters of a proactive
command from the ME.
Parameter:
- proactive command ID according to GSM 11.14 (decimal);
these are only those command types that use the AT interface;
SAT commands which are not using the AT interface (not MMI
related SAT commands, e.g. PROVIDE LOCAL INFORMATION)
are executed without sending any indication to the user
1 - REFRESH
16 - SET UP CALL
17 - SEND SS
18 - SEND USSD
19 - SEND SHORT MESSAGE
20 - SEND DTMF
32 - PLAY TONE
33 - DISPLAY TEXT
34 - GET INKEY
35 - GET INPUT
36 - SELECT ITEM
37 - SET UP MENU
Requested command parameters are sent using an #STGI indication:
#STGI:
where depends upon the ongoing proactive command as
follows: