Rainbow Electronics GM862-QUAD-PY User Manual

Page 244

AT Commands Reference Guide

80000ST10025a Rev. 5 - 09/07/08

page 244 of 434

#SRS - Select Ringer Sound

SELINT 0 / 1

Note: if command is issued with = 0 and > 0 then the current
ringing tone is played.

Note: if both and are 0 then the default ringing tone is set as
current and ringing is stopped.

Note: If all parameters are omitted then the behaviour of Set command is
the same as Read command

AT#SRS?

Read command reports current selected ringing and its status in the form:

#SRS: ,

where:
- ringing tone number
1..max
- ringing status
0 - selected but not playing
1 - currently playing

AT#SRS=?

Test command reports the supported values for the parameters and

#SRS - Select Ringer Sound

SELINT 2

AT#SRS=
[,]

Set command sets the ringer sound.

Parameters:
- ringing tone
0 - current ringing tone
1..max - ringing tone number, where max can be read by issuing the Test

command AT#SRS=?.

- ringing tone playing timer in units of seconds.
0 - ringer is stopped (if present) and current ringer sound is set.
1..60 - ringer sound playing for seconds and, if > 0, ringer

sound is set as default ringer sound.

Note: when the command is issued with > 0 and > 0, the
ringing tone is played for seconds and stored as default ringing tone.

Note: if command is issued with > 0 and = 0, the playing of the
ringing is stopped (if present) and ringing tone is set as current.

Note: if command is issued with = 0 and > 0 then the current
ringing tone is played for seconds.

Note: if both and are 0 then the default ringing tone is set as
current and ringing is stopped.