6 e-mail gprs context activation - #emailact – Rainbow Electronics GM862-QUAD-PY User Manual
Page 369
AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved
page 369 of 434
#SEMAIL - E-mail Sending With GPRS Context Activation
SELINT 2
To complete the operation send Ctrl-Z char (0x1A hex); to exit without
writing the message send ESC char (0x1B hex).
If e-mail message is successfully sent, then the response is OK.
If message sending fails for some reason, an error code is reported
Note: Care must be taken to ensure that during the command execution,
no other commands are issued.
To avoid malfunctions is suggested to wait for the OK or ERROR / +CMS
ERROR:
Note: sending an e-mail with an image attachment can take quite a long
time since it can be over 50Kb to send and can take more than 1 minute.
Note: this command is not allowed if GSM context is active (see
AT#SGACT=0,1).
AT#SEMAIL=?
Test command returns the OK result code.
Example
AT#SEMAIL="[email protected]","subject of the mail",1
>message body… this is the text of the mail message…
CTRL-Z
..wait..
OK
Message has been sent.
3.5.7.6.6 E-mail GPRS Context Activation - #EMAILACT
#EMAILACT - E-mail GPRS Context Ativation
SELINT 0 / 1
AT#EMAILACT[=
[
Execution command deactivates/activates the GPRS context, eventually
proceeding with the authentication with the parameters given with #PASSW
and #USERID.
Parameter:
0 - GPRS context deactivation request
1 - GPRS context activation request
Note: issuing AT#EMAILACT
context for the e-mail, in the format:
#EMAILACT:
where: