Rainbow Electronics GM862-QUAD-PY - Manual (Page 180)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 180 of 434
+CSMP - Set Text Mode Parameters SELINT 2
- depending on the command or result code: GSM 03.38 SMS
Data Coding Scheme (default 0), or Cell Broadcast Data
Coding
Scheme
Note: the current settings are stored through +CSAS
Note: we’re storing through +CSAS the value too, but only as
integer type, i.e. only in its relative format
AT+CSMP? Read command reports the current setting in the format:
+CSMP: ,,,
Note: if the Validity Period Format (’s bit[4]bit[3]) is [00] (i.e. Not
Present), is represented just as a quoted empty string (“”).
AT+CSMP=? Test command returns the OK result code.
Example Set the parameters for an outgoing message with 24
hours of validity period and default properties:
AT+CSMP=17,167,0,0
OK
Set the parameters for an outgoing message with
validity period in enhanced format: the string
actually codes 24 hours of validity period.
AT+CSMP=9,“01A80000000000“
OK
Set the parameters for an outgoing message with
validity period in enhanced format: the string
actually codes 60 seconds of validity period.
AT+CSMP=9,“023C0000000000“
OK
Set the parameters for an outgoing message with
validity period in enhanced format: the string
actually codes 29 hours 85 minutes 30 seconds of
validity period.
AT+CSMP=9,“03925803000000“
OK
#
S
M
S
M
O
D
E
=
1
#
S
M
S
M
O
D
E
=
1
#
S
M
S
M
O
D
E
=
1
Reference GSM 07.05; GSM 03.40; GSM 03.38
3.5.5.2.3 Show Text Mode Parameters - +CSDH
+CSDH - Show Text Mode Parameters SELINT 0 / 1
AT+CSDH[=
[]] Set command controls whether detailed header information is shown in text
mode (+CMGF=1) result codes.