Rainbow Electronics GM862-QUAD-PY - Manual (Page 202)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 202 of 434
+CMGL - List Messages SELINT 2
Reference in integer format
- recipient address, string type , represented in the currently
selected character set (see +CSCS)
- type of number
- arrival time of the message to the SC
- message status as coded in the PDU
Note: If parameter is omitted the command returns the list of sms with
“REC UNREAD” status
.
Note: the order in which the messages are reported by +CMGL
corresponds to their position in the memory storage
AT+CMGL=? Test command returns a list of supported s
#
S
M
S
M
O
D
E
=
1
Reference GSM 07.05, GSM 03.40
3.5.5.3.3 List Messages Improved - @CMGL
@CMGL - List Messages Improved SELINT 0
AT@CMGL
[=] Execution command reports the list of all the messages with status value
stored into message storage ( is the message
storage for read and delete SMs as last settings of command +CPMS).
The parameter type and the command output depend on the last settings of
command +CMGF (message format to be used)
(PDU Mode)
Parameter:
0 - new message
1 - read message
2 - stored message not yet sent
3 - stored message already sent
4 - all messages.
Each message to be listed is represented in the format:
@CMGL: ,,
where
- message position in the memory storage list.
- status of the message
- length of the PDU in bytes
- message in PDU format according to GSM 3.40
(Text Mode)