77 skip escape sequence - #skipesc – Rainbow Electronics GM862-QUAD-PY User Manual

Page 304

AT Commands Reference Guide

80000ST10025a Rev. 5 - 09/07/08

page 304 of 434

#AUTOBND - Automatic Band Selection

SELINT 0 / 1

90 seconds through available bands until a GSM cell is found.

Note: if parameter is omitted the behaviour of Set command is the
same as Read command.

AT#AUTOBND?

Read command returns whether the automatic band selection is enabled or
not in the format:

#AUTOBND:

AT#AUTOBND=?

Test command returns the range of supported values for parameter
.

#AUTOBND - Automatic Band Selection

SELINT 2

AT#AUTOBND=
[]

Set command enables/disables the automatic band selection at power-on.

Parameter:
:
0 - disables automatic band selection at next power-up (factory default)
1 - enables automatic band selection at next power-up; the automatic

band selection stops as soon as a GSM cell is found.

2 - enables automatic band selection in four bands (at 850/1900 and

900/1800); differently from previous settings it takes immediate effect

Note: necessary condition to effectively have automatic band selection at
next power-up (due to either AT#AUTOBND=1 or AT#AUTOBND=2) is that
AT+COPS=0 has to be previously issued

Note: if automatic band selection is enabled the band changes every about
90 seconds through available bands until a GSM cell is found.

Note: if the current setting is different from AT#AUTOBND=2 and we’re
issuing AT#ENS=1, at first next power-up after the ENS functionality has
been activated (see #ENS) the automatic band selection
(AT#AUTOBND=1) is enabled.

AT#AUTOBND?

Read command returns whether the automatic band selection is enabled or
not in the form:

#AUTOBND:

AT#AUTOBND=?

Test command returns the range of supported values for parameter
.

3.5.7.1.77 Skip Escape Sequence - #SKIPESC

#SKIPESC - Skip Escape Sequence

SELINT 0 / 1

AT#SKIPESC[=
[]]

Set command enables/disables skipping the escape sequence +++ while
transmitting during a data connection.