Rainbow Electronics GM862-QUAD-PY - Manual (Page 251)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 251 of 434
3.5.7.1.20 Software Shut Down - #SHDN
#SHDN - Software Shutdown SELINT 0 / 1
AT#SHDN Execution command causes device detach from the network and shut
down. Before definitive shut down an OK response is returned.
Note: after the issuing of this command any previous activity is terminated
and the device will not respond to any further command.
Note: to turn it on again Hardware pin ON/OFF must be tied low.
AT#SHDN? Read command has the same behaviour as Execution command.
#SHDN - Software Shutdown
SELINT 2
AT#SHDN Execution command causes device detach from the network and shut
down. Before definitive shut down an OK response is returned.
Note: after the issuing of this command any previous activity is terminated
and the device will not respond to any further command.
Note: to turn it on again Hardware pin ON/OFF must be tied low.
AT#SHDN=? Test command returns the OK result code.
3.5.7.1.21 Extended Reset - #Z
#Z – Extended reset SELINT 2
AT#Z= Set command loads both base section and extended section of the
specified user profile stored with AT&P.
Parameter
0 – user profile 0
1 – user profile 1
AT#Z=? Test command tests for command existence.
3.5.7.1.22 Wake From Alarm Mode - #WAKE
#WAKE - Wake From Alarm Mode SELINT 0 / 1
AT#WAKE[=
] Execution command stops any eventually present alarm activity and, if the
module is in alarm mode, it exits the alarm mode and enters the normal
operating mode.
Parameter:
- operating mode; any input is possible: no control is made on
the value, although it is mandatory to have it; the module
exits the alarm mode, enters the normal operating mode, any alarm