Rainbow Electronics GM862-QUAD-PY - Manual (Page 228)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 228 of 434
+CMGW - Write Message To Memory SELINT 2
or +CMS ERROR: response before issuing further commands.
(#SMSMODE=1)
(PDU Mode)
AT+CMGW=
[,] (PDU Mode)
Execution command writes in the memory storage a new
message.
Parameter:
- length in bytes of the PDU to be written.
7..164
- message status.
0 - new message
1 - read message
2 - stored message not yet sent (default)
3 - stored message already sent
The device responds to the command with the prompt '>' and waits
for the specified number of bytes.
To write the message issue Ctrl-Z char (0x1A hex).
To exit without writing the message issue ESC char (0x1B hex).
If message is successfully written in the memory, then the result is
sent in the format:
+CMGW:
where:
- message location index in the memory .
If message storing fails for some reason, an error code is reported.
Note: care must be taken to ensure that during the command
execution, no other SIM interacting commands are issued.
#
S
M
S
M
O
D
E
=
1
#
S
M
S
M
O
D
E
=
1
#
S
M
S
M
O
D
E
=
1
#
S
M
S
M
(Text Mode)
AT+CMGW[=
[,
[,]]] (Text Mode)
Execution command writes in the memory storage a new
message.
Parameters:
- destination address, string type represented in the currently
selected character set (see +CSCS).
- type of destination address.
129 - number in national format
145 - number in international format (contains the "+")
- message status.
"REC UNREAD" - new received message unread