Rainbow Electronics GM862-QUAD-PY - Manual (Page 286)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 286 of 434
#ECAM - Extended Call Monitoring SELINT 2
where
- call ID
- call status
0 - idle
1 - calling (MO)
2 - connecting (MO)
3 - active
4 - hold
5 - waiting (MT)
6 - alerting (MT)
7 - busy
- call type
1 - voice
2 - data
- called number (valid only for =1)
- type of
129 - national number
145 - international number
Note: the unsolicited indication is sent along with usual codes (OK, NO
CARRIER, BUSY...).
AT#ECAM? Read command reports whether the extended call monitoring function is
currently enabled or not, in the format:
#ECAM:
AT#ECAM=? Test command returns the list of supported values for
3.5.7.1.51 SMS Overflow - #SMOV
#SMOV - SMS Overflow SELINT 0 / 1
AT#SMOV[=
[]] Set command enables/disables the SMS overflow signalling function.
Parameter:
0 - disables SMS overflow signaling function(factory default)
1 - enables SMS overflow signalling function; when the maximum storage
capacity has reached, the following network initiated notification is send:
#SMOV:
Note: issuing AT#SMOV is the same as issuing the Read command.
Note: issuing AT#SMOV= is the same as issuing the command
AT#SMOV=0.
AT#SMOV? Read command reports whether the SMS overflow signalling function is