Rainbow Electronics GM862-QUAD-PY - Manual (Page 417)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 417 of 434
#DSCRIPT - Delete Script SELINT 0 / 1
sensitive)
Note: if the file is not present an error code is reported.
Example AT#DSCRIPT="Third.py"
OK
#DSCRIPT - Delete Script
SELINT 2
AT#DSCRIPT=
[] Execution command deletes a file from Easy Script® related NVM memory.
Parameter:
- name of the file to delete, string type (max 16 chars, case
sensitive)
Note: if the file is not present an error code is reported.
Example AT#DSCRIPT="Third.py"
OK
3.5.7.10.8 Reboot - #REBOOT
#REBOOT - Reboot SELINT 0 / 1
AT#REBOOT Execution command reboots immediately the unit.
It can be used to reboot the system after a remote update of the script in
order to have the new one running.
AT#REBOOT? Read command has the same behavior of Execution command.
Example AT#REBOOT
…. Module Reboots …
Note This command does not return result codes.
#REBOOT - Reboot
SELINT 2
AT#REBOOT Execution command reboots immediately the unit.
It can be used to reboot the system after a remote update of the script in
order to have the new one running.
Example AT#REBOOT
…. Module Reboots …
Note This command does not return result codes.
3.5.7.10.9 CMUX Interface Enable - #CMUXSCR
#CMUXSCR - CMUX Interface Enable SELINT 2
AT#CMUXSCR= Set command enables/disables the GSM 07.10 multiplexing protocol control