Rainbow Electronics GM862-QUAD-PY - Manual (Page 347)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 347 of 434
#GPRS - GPRS Context Activation SELINT 0 / 1
0 - GPRS context deactivation request
1 - GPRS context activation request
In the case that the GPRS context has been activated, the result code OK is
preceded by the intermediate result code:
+IP:
reporting the local IP address obtained from the network.
Note: issuing AT#GPRS reports the current status of the GPRS
context, in the format:
#GPRS:
where:
0 - GPRS context deactivated
1 - GPRS context activated
2 - GPRS context activation pending.
Note: issuing AT#GPRS= is the same as issuing the command
AT#GPRS=0.
Note: if you request a GPRS context deactivation during a call issuing either
AT#GPRS=0 or AT#EMAILACT=0 and then, after the call termination, you
want to request a GPRS context activation through #GPRS, you need to
issue the following sequence of three commands
AT#GPRS=1
OK
AT#GPRS=0
OK
AT#GPRS=1
OK
AT#GPRS? Read command has the same effect as the Execution command
AT#GPRS.
AT#GPRS=? Test command returns the allowed values for parameter .
Example AT#GPRS=1
+IP: 129.137.1.1
OK
Now GPRS Context has been activated and our IP is
129.137.1.1
AT#GPRS=0
OK