Rainbow Electronics GM862-QUAD-PY - Manual (Page 326)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 326 of 434
3.5.7.4 FTP AT Commands
3.5.7.4.1 FTP Time-Out - #FTPTO
#FTPTO - FTP Time-Out SELINT 0 / 1
AT#FTPTO[=
] Set command sets the time-out used when opening either the FTP control
channel or the FTP traffic channel.
Parameter:
- time-out in 100 ms units
100..5000 - hundreds of ms (factory default is 100)
Note: The parameter is not saved in NVM.
Note: if parameter is omitted the behaviour of Set command is the
same as Read command.
AT#FTPTO? Read command returns the current FTP operations time-out, in the format:
#FTPTO:
AT#FTPTO=? Test command returns the range of supported values for parameter
#FTPTO - FTP Time-Out
SELINT 2
AT#FTPTO=
[] Set command sets the time-out used when opening either the FTP control
channel or the FTP traffic channel.
Parameter:
- time-out in 100 ms units
100..5000 - hundreds of ms (factory default is 100)
Note: The parameter is not saved in NVM.
AT#FTPTO? Read command returns the current FTP operations time-out, in the format:
#FTPTO:
AT#FTPTO=? Test command returns the range of supported values for parameter
3.5.7.4.2 FTP Open - #FTPOPEN
#FTPOPEN - FTP Open SELINT 0 / 1
AT#FTPOPEN=
,
,
,
Execution command opens an FTP connection toward the FTP server.
Parameters:
- string type, address and port of FTP server (factory default
port 21).
- string type, authentication user identification string for FTP.
- string type, authentication password for FTP.
0 - active mode (default)