Rainbow Electronics GM862-QUAD-PY - Manual (Page 423)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 423 of 434
$GPSS - GPS Serial Port Speed SELINT 0 / 1 / 2
19200
38400
57600
Note: the new setting is stored through $GPSSAV
AT$GPSS? Read command returns the current serial ports speed in the format:
$GPSS:
AT$GPSS=? Test command returns the available range for
3.5.7.11.10 Unsolicited NMEA Data Configuration - $GPSNMUN
$GPSNMUN - Unsolicited NMEA Data Configuration SELINT 0 / 1 / 2
AT$GPSNMUN=
[,,,
,,
,]
Set command permits to activate an Unsolicited streaming of GPS data (in
NMEA format) through the standard GSM serial port and defines which
NMEA sentences will be available
Parameters:
0 - NMEA data stream de-activated (default)
1 - NMEA data stream activated with the following unsolicited response
syntax:
$GPSNMUN:
2 - NMEA data stream activated with the following unsolicited response
syntax:
3 - dedicated NMEA data stream; it is not possible to send AT commands;
with the escape sequence ‘+++’ the user can return to command mode
- Global Positioning System Fix Data
0 - disable (default)
1 - enable
- Geographical Position - Latitude/Longitude
0 - disable (default)
1 - enable
- GPS DOP and Active Satellites
0 - disable (default)
1 - enable
- GPS Satellites in View
0 - disable (default)
1 - enable
- recommended Minimum Specific GPS Data
0 - disable (default)
1 - enable
- Course Over Ground and Ground Speed
0 - disable (default)
1 - enable
AT$GPSNMUN? Read command returns whether the unsolicited GPS NMEA data streaming