Rainbow Electronics GM862-QUAD-PY - Manual (Page 160)

AT Commands Reference Guide
80000ST10025a Rev. 5 - 09/07/08
Reproduction forbidden without Telit Communications S.p.A. written authorization - All Rights Reserved page 160 of 434
+CGQMIN - Quality Of Service Profile (Minimum Acceptable) SELINT 2
Reference GSM 07.07; GSM 03.60
3.5.4.7.7 Quality Of Service Profile (Requested) - +CGQREQ
+CGQREQ - Quality Of Service Profile (Requested) SELINT 0 / 1
AT+CGQREQ[=
[
[,
[,
[,
[,
[,]]]]]]] Set command allows to specify a Quality of Service Profile that is used
when the terminal sends an Activate PDP Context Request message to the
network. It specifies a profile for the context identified by the (local) context
identification parameter, .
Parameters:
- PDP context identification (see +CGDCONT command).
- precedence class
- delay class
- reliability class
- peak throughput class
- mean throughput class
If a value is omitted for a particular class then this class is not checked.
Note: a special form of the Set command, +CGQREQ= causes the
requested profile for context number to become undefined.
Note: issuing AT+CGQREQ is the same as issuing the Read
command.
Note: issuing AT+CGQREQ= returns the OK result code.
AT+CGQREQ? Read command returns the current settings for each defined context in the
format:
+CGQREQ: ,,,,,
[+CGQREQ: ,,
,,,[…]]
If no PDP context has been defined, it has no effect and OK result code is
returned.
AT+CGQREQ=? Test command returns as a compound value the type of the current PDP
context and the supported values for the subparameters in the format:
+CGQREQ: ,(list of supported s),
(list of supported s),(list of supported s),
(list of supported s),(list of supported s)
Note: only the “IP” PDP_Type is currently supported.
Example AT+CGQREQ?
+CGQREQ: 1,0,0,3,0,0