Dell PowerEdge VRTX - Manual (Page 324)

Recommended
Response Action One of the job ID values specified as input is duplicated. Remove the duplicated Job ID from
the operation input parameters and retry the operation.
Category Configuration
SubCategory JCP = Job Control
Severity Severity 2 (Warning)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
JCP009
Message Scheduled job was cancelled.
Detailed
Description Scheduled jobs were deleted as a result of a cancel job request. The job cancellation request
is manually or programmatically initiated. Lifecycle Controller enters Recovery mode when
unrecoverable and persistent errors occur.
Recommended
Response Action If the job was not cancelled manually, then Lifecycle Controller may be in Recovery mode. To
verify or change Recovery mode, use F2 Setup to select iDRAC Configuration then Lifecycle
Controller Settings.
Category Configuration
SubCategory JCP = Job Control
Severity Severity 3 (Informational)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
324