Dell PowerEdge VRTX - Manual (Page 322)

SubCategory JCP = Job Control
Severity Severity 2 (Warning)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
JCP016
Message Invalid UntilTime value. A minimum of 12 minutes is required.
Detailed
Description The UntilTime input parameter for the job or job queue creation must be at least 12 minutes
after the value specified in the StartTime parameter.
Recommended
Response Action Set the UntilTime at least 12 minutes after StartTime and retry.
Category Configuration
SubCategory JCP = Job Control
Severity Severity 2 (Warning)
Trap/EventID FALSE
LCD Message No LCD message display defined.
Initial Default. FALSE
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE FALSE
JCP017
Message Job creation request unsuccessful. Maximum number of jobs reached.
Detailed
Description The current job count has reached the maximum value supported. No more jobs are created
until the number of jobs on the system is reduced. Completed jobs are automatically deleted if
they are older than the DeleteOnCompletionTimeout setting.
Recommended
Response Action Perform one of the following to reduce the job count: 1) Delete one or more jobs and retry the
operation. 2) Wait until existing jobs have an elapsed time since completion that is greater than
the delete on completion timeout setting and are automatically deleted. 3) Change the delete
on completion timeout setting to a smaller value so that completed jobs are automatically
deleted sooner.
Category Configuration
322