Dell PowerEdge VRTX - Manual (Page 212)

Severity Severity 3 (Informational)
Trap/EventID 4339
LCD Message No LCD message display defined.
Initial Default. SNMP Alert;#LCD;#Remote System Log
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
TRUE FALSE TRUE TRUE TRUE TRUE FALSE FALSE FALSE
ENC2
Message arg1 was removed..
Arguments
• arg1 = Enclosure Management Module Name
Detailed
Description An Enclosure Management Module (EMM) was removed.
Recommended
Response Action Reinsert the Enclosure Management Module (EMM). See the storage hardware documentation
for information on replacing the EMM.
Category Storage
SubCategory ENC = Storage Enclosr
Severity Severity 1 (Critical)
Trap/EventID 4337
LCD Message No LCD message display defined.
Initial Default. SNMP Alert;#LCD;#Remote System Log
Filter
Visibility
IPMI Alert SNMP
Alert
Email
Alert
LC Log LCD Power Off Power
Cycle
Reset
TRUE FALSE TRUE TRUE TRUE TRUE FALSE FALSE FALSE
ENC3
Message arg1 is shutdown.
Arguments
• arg1 = Enclosure Name
Detailed
Description The physical disk enclosure is either hotter or cooler than the maximum or minimum allowable
temperature range.
Recommended
Response Action Check for factors that may cause overheating or excessive cooling. For example, verify that the
enclosure fan is working. You should also check the thermostat settings and examine whether
the enclosure is located near a heat source. Make sure the enclosure has enough ventilation
and that the room temperature is not too hot or too cold. Refer to the enclosure documentation
for more diagnostic information.
212