Cmc8503, Cmc8504 – Dell PowerEdge VRTX User Manual

Page 106

Initial Default.

LC Log

Filter

Visibility

IPMI Alert SNMP

Alert

LC Log

LCD

Power Off Power

Cycle

Reset

FALSE

TRUE

FALSE

CMC8503

Message

Unable to access the IPv4 information of the server.

Detailed
Description

CMC is unable to access the IPv4 information for the specified server. Unable to display the
specified servers Launch iDRAC link on the CMC Web interface.

Recommended
Response Action

Enable IPv4 on the specified slots iDRAC via the CMC command line or Web GUI interface, for
the iDRACs launch point to show up on the CMC web GUI. For the command line options or
navigation for Web intereface, see the Trobleshooting section in the CMC Users Guide.

Category

System Health

SubCategory

CMC = Chassis Management Controller

Severity

Severity 1 (Critical)

Trap/EventID

FALSE

LCD Message

No LCD message display defined.

Initial Default.

LC Log

Filter

Visibility

IPMI Alert SNMP

Alert

LC Log

LCD

Power Off Power

Cycle

Reset

FALSE

TRUE

FALSE

CMC8504

Message

Unable to access server:

arg1

, because the NIC is disabled on the identified server.

Arguments

•

arg1 =

slot number

Detailed
Description

The NIC is disabled on the server identified in the message, and the CMC is unable to display
the link to launch the iDRAC web interface.

Recommended
Response Action

Enable the NIC on the server identified in the message using the CMC command line or CMC
Web interface, so that the link to launch iDRAC is displayed on the CMC Web interface. To
enable the NIC for DHCP using RACADM, enter "racadm setniccfg -m server- -d"
where is the server identifed in the message. To enable the NIC using the Web
interface, click Server Overview > select the identified server, go to Setup > select the Enable
LAN check box.