Apple Final Cut Pro 5 - Manual (Page 730)

Chapter 21 Adding Transitions 395
III
Push Slide The second clip pushes the first clip out of view. You can adjust the
push direction.
Spin Slide Boxes of the first clip spin and zoom out to reveal the second clip.
You can adjust the spin about the center of the box and the
number of boxes.
Split Slide The first clip splits at specific points and slides to reveal the second
clip. You can adjust the orientation of the split.
Swap Slide The first (top) and the second (bottom) clips slide in opposite
directions, swap places, and slide back, revealing the second clip.
You can adjust the slide direction.
Stretch
Cross Stretch The first clip is squeezed as the second clip stretches from the
specified edge to the opposite edge.
Squeeze The first clip is squeezed from the opposite edges toward the
center to reveal the second clip. You can specify the squeeze
orientation.
Squeeze and Stretch The first clip is squeezed from the opposite edges toward the
center and stretches in a perpendicular direction to reveal the
second clip. You can adjust the squeeze orientation.
Stretch The second clip stretches from the specified edge over the first clip.
Wipe
Band Wipe Wipes a band across the first clip to reveal the second. You can
specify the number of bands and the wipe direction.
Center Wipe A linear wipe from a specified point on the first clip reveals the
second clip. You can adjust the wipe direction.
Checker Wipe Checkered boxes appear on the first clip to reveal the second clip.
You can adjust the number of boxes and the wipe direction.
Checkerboard Wipe Checkered boxes wipe individually on the first clip to reveal the
second. You can adjust the number of boxes and the wipe
direction.
Clock Wipe A rotational wipe over the first clip reveals the second. You can
adjust the start and direction of the wipe and the center point of
the rotation.
Edge Wipe A linear wipe from the edge of the first clip reveals the second clip.
You can adjust the wipe direction.
Gradient Wipe Uses a gradient wipe image to wipe across the first clip, revealing
the second clip. You can adjust the softness of the wipe and invert
the gradient wipe image. By default, the transition wipes
horizontally from left to right. You can override this by dragging an
image onto the gradient clip well.
Inset Wipe A rectangular wipe from the specified edge or corner of the first
clip reveals the second clip.
Slide