Allied Telesis AT-S99 - Manual (Page 95)

AT-S73 and AT-S99 Management Software User’s Guide
95
Configuring the Network Time Protocol Client
The AT-CV5M02 Management Card has an NTP client for setting the date
and time from a Network Time Protocol (NTP) server on your network or
the Internet. The card adds the date and time to event messages and
SNMP traps. Refer to “Access to Your Network” on page 28 for the NTP
client requirements.
Menus
To configure the NTP client from the menus:
1. From the Main Menu, select Configuration. The Configuration menu
is shown in Figure 20 on page 80.
2. From the Configuration menu, select System Configuration.
3. From the System Configuration Menu, select System Clock
Configuration to display the menu in Figure 26 on page 93.
4. Select the NTP Server field and enter the IP address of the NTP
server.
5. To enable the client, select Enable NTP.
6. To save your changes in the master configuration file, return to the
Configuration Menu and select Save System and All Line Card
Configurations.
Web Browser
To configure the NTP client from the web browser windows:
1. Select Configuration from the menu bar.
2. If the System tab is not selected, select it. The System tab is shown in
Figure 23 on page 83.
3. in the System Information section, click Edit.
4. Select the NTP Server field in the popup window and enter the IP
address of the NTP server.
5. Select Enable from the NTP pull-down menu to activate the client. Or,
to disable the client, select Disable.
6. Click Update.
7. To save your changes in the master configuration file, select the Files
tab in the Configuration window and click Save System
Configuration and All Cards Configurations and Apply.