Allied Telesis AT-S99 - Manual (Page 185)

AT-S73 and AT-S99 Management Software User’s Guide
185
Restoring the
Default
Parameter
Settings
To restore a remote line card to its default parameter settings:
Caution
This procedure may disrupt network operations. Some network
traffic may be lost.
Note
A remote line card that is returned to its default values continues to
support remote peer management because the default operating
mode for the AT-CM Line Cards is OAM visible.
1. From the Remote Module Status & Configuration window, select the
Line Card Configuration tab.
2. Click the Default Configuration tab. This tab displays the default
settings for the line card. An example of the tab is shown in Figure 64
on page 155.
3. To return the card’s parameter settings to the default values, click the
Return to Default Configuration button. The parameter settings on
the card are returned to the default settings.
Restoring the
Last Saved
Configuration
This procedure restores a remote line card to the last saved configuration
in the master configuration file on the management card in the local
chassis. You might perform this procedure to discard any parameter
changes that you made to a line card but did not saved, or to configure a
new line card with the save settings as its predecessor. For more
information, refer to “Configuration Files” on page 29.
Caution
This procedure may disrupt network operations. Some traffic may be
lost.
1. From the Remote Module Status & Configuration window, select the
Line Card Configuration tab.
2. Select the Last Saved Configuration tab.
3. To return the line card to its last saved configuration, click the Restore
to Last Saved Configuration button.