Allied Telesis AT-S99 - Manual (Page 78)

Chapter 3: Starting a Management Session
78
21. Return to the line card’s Module Configuration Menu.
22. To configure other parameters on the line card, refer to Chapter 5,
”Configuring AT-CM and AT-CV Media Converter Line Cards” on page
127.
23. Return to the Main Menu and select Configuration.
24. From the Configuration menu, select Save System and All Line Card
Configurations.
25. You can now remove the line card from the slot.
26. To assign the same configuration to another AT-CM Line Card, install
the card in the same slot. Wait a full minute for the line card to initialize
its management software and to receive its parameter settings from
the management card. Afterwards, remove the card. Repeat this step
to assign the same settings to other AT-CM Line Cards.