Allied Telesis AT-S99 - Manual (Page 84)

Chapter 4: Configuring the AT-CV5M02 Management Card
84
hop to reaching the remote subnet and has to be a member of the
same subnet as the card’s IP address.
ˆ The default values are 10.0.0.1 for the IP address, 255.255.255.0
for the subnet mask, and 0.0.0.0 for the default gateway address.
5. To activate the DHCP client so that the card obtains its IP address
from a DHCP server on the network, select Enable DHCP. Or, to
deactivate the client so that you can assign the IP address manually,
select Disable DHCP. Here are the guidelines to using the DHCP
client:
ˆ The 10/100Base-TX port on the management card has to be
connected to a network device, such as a Fast Ethernet switch.
The DHCP requests are transmitted from that port.
ˆ If the card already has a static IP address, the address is
overwritten by the address from the DHCP server.
ˆ When the client is activated, the management card issues two
requests for an IP address configuration from the DHCP server. If
the DHCP server does not respond, the management card
operates without an IP address configuration.
6. Click Update.
If you changed the IP address of the management card, your
management session ends. To continue managing the unit and to save
your changes, start a new management session with the card’s new IP
address.
7. To save your changes in the master configuration file, select the Files
tab in the Configuration window and click Save System
Configuration and All Cards Configurations and Apply.