Allied Telesis AT-S99 - Manual (Page 113)

AT-S73 and AT-S99 Management Software User’s Guide
113
Restoring the Default Values on the AT-CV5M02 Management Card
In this section are the procedures for restoring the default values to all of
the following operating parameters on the AT-CV5M02 Management
Card:
ˆ IP address configuration
ˆ Name, location, and contact
ˆ IP addresses of SNMP trap receivers
ˆ SNMPv1 and SNMPv2c community strings
ˆ SNMPv3 configurations
ˆ Management security (i.e., passwords, console timer, etc.)
ˆ Network Time Protocol client
ˆ Syslog client
ˆ 10/100Base-TX port
ˆ Temperature threshold
ˆ Console port's baud rate
Note
Before performing these procedures, save the current configurations
of the AT-CM Line Cards in the master configuration file. For
instructions, refer to “Saving Your Configuration Changes” on
page 64.
Note
A management card resets when its parameter settings are returned
to the default values. It will not respond to management commands
for one minute while it initializes its management software. To
resume managing the device, start a local management session on
the unit.
Restoring the default settings on the management card does not interrupt
the network operations of the line cards in the chassis.
Menus
To restore the default settings on the management card from the menus:
1. If the chassis has two management cards, remove the standby card.
2. From the Main Menu, select Configuration. The Configuration menu
is shown in Figure 20 on page 80.
3. Select Return System Configuration to Default. A confirmation
prompt is displayed.