Allied Telesis AT-S99 - Manual (Page 100)

Chapter 4: Configuring the AT-CV5M02 Management Card
100
Table 9 lists the event messages.
Table 9. Event Log Messages
Message Chassis
Classi-
fication
Definition
n Voltage Failed AT-CV5000 Report The AT-PWR14 or AT-PWR15 Power
Supply Module in the AT-CV5000 Chassis
had an output voltage failure. The variable
n can be 3.3V, 5V, or 12V and signals
which voltage failed.
Clear The AT-PWR14 or AT-PWR15 Power
Supply Module resumed normal
operations or was replaced.
Copper port failure on
remote linecard n. AT-CV1200
AT-CV1203
AT-CV5000 Report The twisted pair port on a remote AT-CM
Line Card lost its link to its network
device. This message requires remote
peer management.
Clear The twisted pair port on a remote AT-CM
Line Card established a link to its network
device. This messages requires remote
peer management.
CPM Card Reboot AT-CV1200
AT-CV1203
AT-CV5000 Report The AT-CV5M02 Management Card was
reset.
CV1203 Local RPS
Failure A/B AT-CV1203 Report One of the two external power supplies
connected to the AT-CV1203 Chassis
failed. (A failed power supply has no
detectable output voltages.) “A” and “B”
designate the power connectors on the
back panel of the chassis. This message
only appears if the AT-CV1203 Chassis
has two power supplies and just one of
the power supplies fails.
Clear A power supply connected to the
AT-CV1203 Chassis resumed normal
operations or was replaced.