Allied Telesis AT-S99 - Manual (Page 284)

Chapter 11: Uploading and Downloading Files
284
Downloading the Master Configuration File to a Management Card
These procedures are used to download a master configuration file to a
management card: This procedures use TFTP and can be performed from
either a local management session or a remote Telnet or web browser
management session of the management card.
Note
The current configuration settings of the management card will be
overwritten by the configuration settings contained in the
downloaded file. This includes the IP address, subnet mask, and
DHCP status.
Caution
These procedures may disrupt the network operations of the AT-CM
Line Cards in the chassis. The parameter settings may change for
those line cards that reside in chassis slots where the auto-copy
feature is activated in the new master configuration file.
Menus
To download the master configuration file to a management card from the
menus:
1. If the chassis has two AT-CV5M02 Management Cards, remove the
standby card.
1. From the Main Menu, select Configuration. The Configuration Menu
is shown in Figure 20 on page 80.
2. From the Configuration Menu, select Configuration File Upload/
Download with TFTP to display the menu in Figure 129 on page 281.
3. Select Download Configuration File to Management Card. This
prompt is displayed:
TFTP Server IP Address-> _
4. Enter the IP address of the TFTP server. This prompt is displayed:
Configuration File Name-> _
5. Enter the filename of the configuration file on the TFTP server. Be sure
to include the extension “.cfg”. This prompt is displayed:
Ready to download configuration file through TFTP.
Warning: During Download Configuration Management activ-
ity is disabled.