Allied Telesis AT-S99 - Manual (Page 72)

Chapter 3: Starting a Management Session
72
3. From the System Configuration Menu, select System Clock
Configuration.
4. To set the date and time manually, do the following:
a. Select System Date (mm/dd/yy) and enter a new date in the
format “mm/dd/yy” format. For example, April 5, 2008 would be
4/5/08.
b. Select System Time (hh:mm:ss) and enter a new time in 24-hour,
“hh:mm:ss” format. The seconds are optional. For example, 8:15
am would be 08:15.
5. To configure the NTP client, do the following:
a. Select NTP Server and enter the IP address of the NTP server.
b. To enable the client, select Enable NTP.
6. Return to the Main Menu.
Naming the
Management
Card
The management card will be easier to identify if you assign it a name.
The name is displayed at the top of the menus in the management
software. To assign a name to the management card:
1. From the Main Menu, select Configuration.
2. From the Configuration menu, select System Configuration.
3. Select System Name and enter a new name of up to 39 characters for
the card. Spaces and special characters are permitted.
4. Return to the Main Menu. The card’s new name does not appear until
you return to the Main Menu.
Saving Your
Changes
This completes the initial configuration of the management card. To save
your changes in the master configuration file on the management card:
1. From the Main Menu, select Configuration.
2. From the System Configuration Menu, select Save System and All
Line Card Configurations. The following message is displayed:
Saving system and all line card configuration ...
After the management card updates its master configuration file, it
displays this prompt:
Saving system and all line card configuration ... OK
Press any key to continue...
3. Return to the Main Menu.