Allied Telesis AT-S99 - Manual (Page 154)

Chapter 5: Configuring AT-CM and AT-CV Media Converter Line Cards
154
4. To view the default settings of the line card prior to activating them,
select Display Default Configuration. An example of the window is
shown in Figure 63.
Figure 63. Display Default Configuration Window
5. To return the parameter settings on the line card to the default values,
select Return Line Card to Default Configuration from the Line Card
Configuration Menu.
6. At the confirmation prompt, select Yes to return the parameter settings
on the line card to the default values or No to cancel the procedure. If
you select Yes, the parameter settings on the card return to the default
settings. If the card’s previous operating mode was OAM visible, the
card resumes normal network operations almost immediately. If,
however, the card’s previous operating mode was another operating
mode, the card has to initialize its management software, a process
that takes about one minute. During this process, this message is
displayed on the screen:
Setting operation mode and resetting line card.
Display Default Configuration
Slot: 11 Module: AT-CM202
Operational Mode: OAM Visible
Port A(100BaseFX) Port B(100Base-TX)
Port Enable: Enabled Enabled
Negotiation: -- Auto negotiate
Duplex: -- --
MDI/MDIX: -- --
Flow Control Enable Enable
Ingress Rate Limit: No Limit No Limit
Egress Rate Limit: No Limit No Limit
OAM Configuration
Admin State: Enabled
Mode: Passive
Maximum OAMPDU Size: 1518
Unidirectional Support: Yes
Loopback Support: Yes
Event Support: No
Variable Retrieval Support: Yes
Return to Line Card Configuration...