Menus, Figure 52. display current configuration window – Allied Telesis AT-S99 User Manual
Page 136
Chapter 5: Configuring AT-CM and AT-CV Media Converter Line Cards
136
Displaying the Parameter Settings on AT-CM Line Cards
Menus
To view the current parameter settings of the AT-CM Line Cards from the
menus:
1. From the Main Menu, select Module Status and Configuration to
display the Module Status and Configuration menu shown in Figure 48
on page 128.
2. From the Module Status and Configuration menu, select the AT-CM
Line Card you want to view. You can view only one line card at a time.
The Module Configuration Menu in Figure 53 on page 139 is
displayed.
3. Select Line Card Configuration to display the menu in Figure 62 on
4. Select Display Current Configuration. An example of the window is
shown in Figure 51.
Figure 51. Display Current Configuration Window
Display Current Configuration
Slot: 11 Module: AT-CM202-v2
Operational Mode: OAM Visible
Port A(100BaseFX)
Port B(100Base-TX)
Port Enable:
Enabled
Disabled
Negotiation:
--
Manual negotiate
Duplex:
--
Half
MDI/MDIX:
--
MDI
Flow Control
Enable
Enable
Ingress Rate Limit:
No Limit
No Limit
Egress Rate Limit:
No Limit
No Limit
OAM Configuration
Admin State:
Enabled
Mode:
Active
Maximum OAMPDU Size:
64
Unidirectional Support:
Yes
Loopback Support:
Yes
Event Support:
Yes
Variable Retrieval Support:
Yes
Return to Line Card Configuration...