Allied Telesis AT-S99 - Manual (Page 68)

Chapter 3: Starting a Management Session
68
The functions of these commands are given here:
ˆ Copy Active Card Configuration to Standby Card - This command
copies the temporary master configuration file from DRAM in the
active management card to DRAM in the standby card.
ˆ Save Current Configuration of Standby Card - This command instructs
the standby card to copy its master configuration file from DRAM to
flash memory for permanent storage.
You use these commands to manually copy the master configuration file
from the active management card to the standby card and to store the file
in the standby card’s flash memory. However, there is little likelihood you’ll
ever need to use these commands because the active and standby cards
do this automatically. The only time you might be inclined to use them is if
you suspect that the standby card isn’t properly updating its master
configuration file. However, a standby management card that is not
updating its configuration file might be faulty and should probably be
replaced. For more information, refer to “Redundant Management Cards”
on page 26.