Allied Telesis AT-S99 - Manual (Page 264)

Chapter 10: Configuring SNMPv3
264
Configuring the SNMPv3 Target Address Table
The SNMPv3 Target Address Table is used to designate the IP addresses
of hosts to receive notifications. The SNMPv3 Target Address Table is
linked internally to the SNMPv3 Notify Table through the Tag List
parameter. The entries in the SNMPv3 Notify Table receive the host IP
addresses from the entries in the SNMPv3 Target Address Table.
The parameters of the entries in the SNMPv3 Target Address Table are:
ˆ Target Address Name
ˆ Target IP Address
ˆ UDP Port
ˆ Timeout Value
ˆ Number of Retries
ˆ Tag List
ˆ Target Parameters
ˆ Storage Type
The parameters are defined in Table 33 on page 265.
To access the Configure SNMPv3 Target Address Table from the menus:
ˆ From the Main Menu, select Configuration -> System Configuration
- > SNMPv3 Configurations -> Configure SNMPv3 Target Address
Table. The Configure SNMPv3 Target Address Table menu is shown in
Figure 121.
Figure 121. Configure SNMPv3 Target Address Table Menu
Configure SNMPv3 Target Address Table
Converteon
Create SNMPv3 Table Entry
Delete SNMPv3 Table Entry
Modify SNMPv3 Table Entry
Display SNMPv3 Table Entry
Return to SNMPv3 Configurations ...