Allied Telesis AT-S99 - Manual (Page 270)

Chapter 10: Configuring SNMPv3
270
In an SNMPv3 Target Parameters Table entry, the Security Name
parameter is linked to the User Name parameter on the SNMPv3 User
Table. In an SNMPv3 User Table entry, the User Name parameter is used
as an index for the entry. Because the User Name and Security Name
parameters are linked, the information you configure that relates to a User
Table entry must match the information you configure in the SNMPv3
Target Parameters Table entry. In addition, the values configured for the
following parameters in an SNMPv3 Target Parameters Table entry must
match those configured in the corresponding table entry:
ˆ User Name parameter in the SNMPv3 User Table
ˆ View Name parameter in the SNMPv3 View Table
ˆ Group Name, Security Model, and Security Level parameters in the
SNMPv3 Access Table
ˆ User Name, Security Model, Group Name parameters in the SNMPv3
Group Table
Caution
If the values of the Security Model parameter in the SNMPv3 User
Table and the SNMPv3 Target Parameter Table entry do not match,
notification messages are not generated on behalf of this User
(Security) Name.
Storage Type [V-Volatile, N-
NonVolatile] The possible values are:
V-Volatile
This selection blocks the management card from saving the
entry in the master configuration file.
N-NonVolatile
This selection allows the management card to save the entry in
the master configuration file when a save command is issued.
Allied Telesis recommends this storage type.
Row Status This parameter appears only when you display the SNMPv3
Target Parameters Table. The Active value indicates the entry
takes effect immediately.
Table 34. SNMPv3 Target Parameters Table Parameters
Parameter Description