Allied Telesis AT-S99 - Manual (Page 118)

Chapter 4: Configuring the AT-CV5M02 Management Card
118
4. To resume managing the chassis, wait twenty to thirty seconds for the
standby card to transition to the active state and, afterwards, start a
new management session.
Note
For explanations of the two other selections in the Management
Card Redundancy menu, refer to “Saving Your Configuration
Changes” on page 64.
Web Browser
To activate the standby management card from the web browser windows:
1. Select Management Card Redundancy from the menu bar to display
the tab in Figure 42.
Figure 42. Management Card Redundancy Tab
2. In the section Switch Over Management Cards, click Select. A
confirmation prompt is displayed.
3. In the confirmation prompt, click Yes and Apply to activate the
standby card or No and Apply to cancel the procedure. If you select
Yes, your management session ends as the active and standby
management cards change states.
4. To resume managing the chassis, wait twenty to thirty seconds for the
standby card to transition to the active state. Afterwards, start a new
management session.
Note
For explanations of the two other selections in the Management
Card Redundancy tab, refer to “Saving Your Configuration
Changes” on page 64.