beautypg.com

Commissioning preparation, Recommended tools and equipment – Rockwell Automation 7000L PowerFlex Medium Voltage AC Drive (C-Frame) - ForGe Control User Manual

Page 175

background image

Rockwell Automation Publication 7000L-UM301D-EN-P - June 2014

175

Commissioning

Chapter 4

Commissioning Preparation

The following section identifies all the tools and resources required to
successfully commission a PowerFlex 7000 “C” Frame drive line-up. In addition,
it identifies how to obtain the required equipment in the event that it is not
readily available prior to commissioning the drive. It is recommended that all
items listed below be obtained prior to attempting to commission the drive.
Ensure that the contents of this section are reviewed and that the uses of the
equipment described within are understood prior to commencing
commissioning of the drive. If further support or additional information is
required, contact your local Rockwell Automation service office or Medium
Voltage Support at (519) 740-4790.

Recommended Tools and Equipment

Hand Tools

Metric and Imperial wrenches, sockets, and Hex keys

Torque wrench

Assortment of screw drivers

Assortment of electrical tools (wire strippers, electrical tape, crimpers, etc.)

Electrical Equipment

High voltage gloves – 10 kV insulation rating (minimum)

Approved high voltage potential tester – 10 kV rating (minimum)

Anti-static strap

Test Equipment

100 MHz oscilloscope with at least two channels and memory

600V (1000V rating) digital multimeter with assorted clip leads

5000V megohmmeter

Computer Requirements and Software

Laptop computer (486 or higher installed with Microsoft (MS) Windows)

Microsoft HyperTerminal (Provided with MS Windows)

Rockwell Automation Software (RS) drive tools (Optional)

RS Logix

(1)

Required computer cables

9-Pin Null Modem

(2)

9-Pin Serial

(2)

Remote I/O (SCANport DeviceNet

…)

(3)

PLC Communications Cable

(1)

(1) Only required when PLC has been prvided with the drive.
(2) Refer to Publication 7000-UM151_-EN-P, Chapter 5 – Component Definition and Maintenance.
(3) Only required when Remote I/O has been provided with the drive.