CCTV Camera Pros Geovision 8.5 Multicam Digital Surveillance System - Manual (Page 598)

580
11.11.2 Allowing Remote Control at DVR
The network traffic of WebCam server can be controlled when the DVR permits the remote control
from the Bandwidth Control program by the following steps:
1. Click the Network button (No.11, Figure 1-2), and select WebCam Server.
2. On the General tab, select the Run Bandwidth Control server option. When this option is
enabled, on the Control Center Server option list, the “Bandwidth Control Service” is marked with
a check.